O-Ring fluoroelastomer FPM/FKM/Viton® and perfluoroelastomer FFPM/FFKM/HPSealing® seals: Guarantee of the best performance, always.

A wide range of high quality products and high performance made with the best mixes. O-rings (ISO 3601 / ex DIN 3771), O-rings with 30° joint junctions, lip seals, X-rings, D-Rings washers, flat gaskets, special productions, customized or total custom products (ISO 3302).
Each application requires specific properties to obtain the best sealing solutions technology

High technology and automation machining lines combined with careful planning and scrupulous industrial processes ensure a high degree of production flexibility while guaranteeing the customer an ideal product made with the highest productive efficiency: on the one hand, the possibility of requesting a Just In Time production system and, on the other hand, the opportunity to make special custom made production volumes on the basis of the technical specifications provided, thus responding readily to the most different customization requests.

Elastomer O-rings: Standard and non-standard O-ring sizes

ISO 3601-1
Fluid power systems — O-rings
Inside diameters, cross-sections, tolerances and designation codes
Inside diameters, d1, cross-sections (section diameter), d2, and tolerances. class A and class B

ISO 3601-3
Fluid power systems — O-rings.
Quality acceptance criteria:Grade N, Grade S.

ISO 3302
Rubber -- Tolerances for products -- Part 1: Dimensional tolerances

ISO 48
Rubber, vulcanized or thermoplastic — Determination of hardness (hardness between 10 IRHD and 100 IRHD): Method M (microtest; mIRHD) is essentially a scaled-down version of the normal test method N, permitting the testing of thinner and smaller test pieces.
It is appropriate for rubbers with a hardness in the range 35 IRHD to 85 IRHD, but can also be used for hardnesses in the range 30 IRHD to 95 IRHD.

ISO 815-1
Rubber, vulcanized or thermoplastic -- Determination of compression set -- Part 1: At ambient or elevated temperatures

ISO 815-2
Fluid power systems — O-rings
Rubber, vulcanized or thermoplastic -- Determination of compression set -- Part 2: At low temperatures

with 30° joint line
D-Rings according to customer drawing
Washer with square, rectangular
section or according to customer drawing
Elastomer Seals DIN 3869
Moulded parts according customer drawing:
Frames, Bellows, Membranes, V-Seal ...